I'm having two problems with IDE nowadays.
1. ATA doesn't work with LS-120. That's not new. But ATA does seem to crash on
me, and there's no dump() so I can't figure out why.
2. wd supports UDMA on my chipset, but won't enable any kind of DMA on my
new Seagate, which does UDMA2 fine with ATA
Any ideas?
ide_pci0: <Acer Aladdin IV/V (M5229) Bus-master IDE controller> at device 15.0
on pci0
wdc0 at port 0x1f0-0x1f7 irq 14 flags 0xa0ffa0ff on isa0
wdc0: unit 0 (wd0): <ST36422A>, 32-bit, multi-block-16
wd0: 6103MB (12500460 sectors), 13228 cyls, 15 heads, 63 S/T, 512 B/S
wdc0: unit 1 (atapi): <NEC CD-ROM DRIVE:285/3.04>, removable,
dma, iordy
wcd0: drive speed 2067KB/sec, 128KB cache
wcd0: supported read types: CD-R, CD-DA
wcd0: Audio: play, 16 volume levels
wcd0: Mechanism: ejectable tray
wcd0: Medium: no/blank disc inside, unlocked
wdc0: interrupting at irq 14
wdc1 at port 0x170-0x177 irq 15 flags 0xa0ffa0ff on isa0
wdc1: unit 1 (wd3): <Maxtor 71626 AP>, DMA, 32-bit, multi-block-32
wd3: 1554MB (3183264 sectors), 3158 cyls, 16 heads, 63 S/T, 512 B/S
wdc1: unit 0 (atapi): <LS-120 COSM 02 UHD Floppy/0271C09T>,
removable, iordy
wfd0: medium type unknown (no disk)
wdc1: interrupting at irq 15
Brian Feldman _ __ ___ ____ ___ ___ ___
gr...@unixhelp.org _ __ ___ | _ ) __| \
FreeBSD: The Power to Serve! _ __ | _ \ _ \ |) |
http://www.freebsd.org _ |___)___/___/
To Unsubscribe: send mail to majord...@freebsd.org
with "unsubscribe freebsd-current" in the body of the message
