It seems oZZ!!! wrote: > > > controller ata0 > > device atadisk0 # ATA disks > > device atapicd0 # ATAPI CDROM's > > > After (fastest(!!!)) boot: > $ dmesg > ...... > chip1: <Intel 82371AB PCI to ISA bridge> rev 0x01 on pci0.7.0 > ata-pci0: <Intel PIIX4 IDE controller> rev 0x01 on pci0.7.1 > ata0 at 0x01f0 irq 14 on ata-pci0 > ata1 at 0x0170 irq 15 on ata-pci0 > ............... > > ad0: <FUJITSU MPA3026AT/9147> ATA-3 disk at ata0 as master > ad0: 2503MB (5126964 sectors), 5086 cyls, 16 heads, 63 S/T, 512 B/S > ad0: 16 secs/int, 0 depth queue > ad1: <WDC AC21200H/05.01E05> ATA-? disk at ata1 as master > ^^^^^ ???? > ad1: 1222MB (2503872 sectors), 2484 cyls, 16 heads, 63 S/T, 512 B/S > ad1: 16 secs/int, 0 depth queue > acd0: <MATSHITA CR-581-M/106A> CDROM drive at ata1 as slave > acd0: drive speed 689KB/sec, 128KB cache > acd0: supported read types: CD-DA > acd0: Audio: play, 256 volume levels > acd0: Mechanism: ejectable tray > acd0: Medium: CD-ROM 120mm data disc loaded, unlocked > changing root device to ad0s1a > ......... > > ATA-? ??? > ^^^^^ > Does it right?
Yup, that because the drive doesn't report what version the of the ATA spec its conformant to. > How i can create ad0s1a & etc. slises? i can't find anythink in > /usr/src/etc/etc.i386/MAKEDEV... Thats because the are not there yet, just use wd0 wd1 etc etc that will work fine , and makes it easier fot people to test the new setup without too much changing around. -Søren To Unsubscribe: send mail to majord...@freebsd.org with "unsubscribe freebsd-current" in the body of the message
