Greetings, I also have a Creative Labs Sound Blaster PCI128 installed, and though I followed your instructions below I am not havine what I would call promising results.
At 12:21 PM 1/10/99 +0100, Luigi Rizzo wrote: >you need a -current system with the "pcm" device, then I am running 3.1-STABLE, but since your instructions were dated befoe the split, I assumed this would be OK. I have added the pnp0 controller and the pcm0 device to my kernel. /kernel: es1: <AudioPCI ES1370> rev 0x00 int a irq 12 on pci0.10.0 /kernel: pcm1: using I/O space register mapping at 0xb800 > cd /dev > ./MAKEDEV snd1 I have done this. > cat somefile > /dev/audio When I cat'd a .au file I had on my system there was a pause before I got my prompt back, but complete silence from the speakers. Since I did not get any errors addressing the device, could this be a volume problem? If so, is there any way to adjust the volume. If not a volume problem, do you have any suggestions? Any help appreciated! -ck To Unsubscribe: send mail to majord...@freebsd.org with "unsubscribe freebsd-current" in the body of the message
