Peter Jeremy wrote:
> Mike Smith <m...@smith.net.au> wrote:
> >> The kernel has been built with gcc-2.8.1 -O2.
> >
> >Please rebuild with the system compiler and -O at most.
>
> It makes no difference. The kernel loads and runs happily from the
> old bootloader, but crashes with /boot/loader. (I disabled my
> gcc-2.8.1, changed make.conf to -O, re-ran config; make depend; make;
> make install).
>
> Something that `fell off' my previous posting (it was implied in the
> context of my original posting):
>
> Both disks have Booteasy installed. wd0 has the old bootblocks
> (from 2.2.6-RELEASE) and FreeBSD 2.x installed on slice 2. wd2
> has the new bootblocks and 3.0-current built from CTM 'cvs-cur 4996'
> occupying all of slice 1 (which is all of the disk).
>
> The boot sequences are:
> disk0 booteasy offers: W95, FreeBSD, Disk1:
> - select FreeBSD and 2.x boots successfully
> - select `disk1' and the disk1 booteasy offers: BSD, disk0
>
> Select BSD and the new /boot/loader comes up. If I let it continue, I
> wind up with the 3.0 (customised, ELF) kernel booting successfully.
>
> If I abort /boot/loader's autostart (giving me a prompt), then (as per
> Peter Wemm's elfday tutorial) issue the commands:
> set currdev=disk1s2a
> load /kernel
> boot -s
> the system displays garbage on the screen and doesn't respond to anything
> gentler than the reset button.
>
> If I load the GENERIC 2.2.6-RELEASE kernel, ("load /kernel.GENERIC" above)
> then it works.
>
> Any suggestions as to my next step?
Please e-mail me a copy of the kernel (or put it up for ftp, if you
prefer), and I'll take a look.
--
Robert Nordier
To Unsubscribe: send mail to majord...@freebsd.org
with "unsubscribe freebsd-current" in the body of the message
