Splitting the thread...
"Daniel C. Sobral" <d...@newsguy.com> wrote:
>> /boot/loader could load my 2.x kernel (although it happily handled
> ^^^^^^^^^^
>You mean "could not", right?
That's correct.
>Is it kzipped, your 2.x kernel? (Is there any detail about it that
>you think it is not relevant? :-)
Further point: a GENERIC 2.2.6-RELEASE kernel boots successfully, so
it is something about my kernel. The config file and boot messages
are below. FWIW, boot -d still hangs, so it's dying fairly early.
The kernel is not gzip'd - it's installed using `make install'.
System details: PII-266 with IDE disks:
primary master: wd0: dualboot (W95/FreeBSD 2.x)
primary slave: ATAPI cdrom
secondary master: wd2: FreeBSD 3.0 (not dangerously dedicated)
secondary slave: not present
The kernel has been built with gcc-2.8.1 -O2.
My 2.x config file:
machine "i386"
cpu "I686_CPU"
ident gsm_xt
maxusers 20
options FAILSAFE #Be conservative
config kernel root on wd0
options "COMPAT_43" #Compatible with BSD 4.3 [KEEP THIS!]
options USER_LDT # user-level control of i386 LDT
options SYSVSHM
options SHMMAX=16777216
options SYSVSEM
options SYSVMSG
options "MD5"
options DDB
options KTRACE #kernel tracing
options PERFMON
options UCONSOLE #Allow users to grab the console
options USERCONFIG #boot -c editor
options VISUAL_USERCONFIG #visual boot -c editor
options INET #InterNETworking
pseudo-device ether
pseudo-device loop
pseudo-device bpfilter 4
pseudo-device tun 1
options FFS #Berkeley Fast Filesystem
options NFS #Network Filesystem
options "CD9660" #ISO 9660 Filesystem
options FDESC #File descriptor filesystem
options KERNFS #Kernel filesystem
options MFS #Memory filesystem
options MSDOSFS #MSDOS Filesystem
options PROCFS #Process filesystem
pseudo-device pty 256
pseudo-device speaker
pseudo-device log
pseudo-device gzip # Exec gzipped a.out's
pseudo-device vn
controller isa0
options "AUTO_EOI_1"
controller pci0
controller pnp0
device sc0 at isa? port "IO_KBD" tty irq 1 vector scintr
options MAXCONS=12 # number of virtual consoles
device npx0 at isa? port "IO_NPX" flags 0x1 irq 13 vector npxintr
controller wdc0 at isa? port "IO_WD1" flags 0x80ff80ff bio irq 14
vector wdintr
disk wd0 at wdc0 drive 0
disk wd1 at wdc0 disable drive 1
controller wdc1 at isa? disable port "IO_WD2" bio irq 15 vector wdintr
disk wd2 at wdc1 disable drive 0
disk wd3 at wdc1 disable drive 1
options ATAPI #Enable ATAPI support for IDE bus
options ATAPI_STATIC #Don't do it as an LKM
device wcd0 #IDE CD-ROM
controller fdc0 at isa? port "IO_FD1" bio irq 6 drq 2 vector fdintr
disk fd0 at fdc0 drive 0
disk fd1 at fdc0 disable drive 1
device lpt0 at isa? port? tty irq 7 vector lptintr
device psm0 at isa? port "IO_KBD" conflicts tty irq 12 vector
psmintr
device apm0 at isa? # Advanced Power Management
device sio0 at isa? port "IO_COM1" tty irq 4 vector siointr
device sio1 at isa? port "IO_COM2" tty irq 3 vector siointr
device pcm0 at isa? port ? tty irq 5 drq 1 flags 0x13 vector pcmintr
device pca0 at isa? port IO_TIMER1 tty
device joy0 at isa? port "IO_GAME"
device tx0
options "CLK_USE_I586_CALIBRATION"
The boot messages:
Copyright (c) 1992-1998 FreeBSD Inc.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
FreeBSD 2.2.6-RELEASE #1: Tue Dec 1 07:58:15 EST 1998
r...@gsmx07.alcatel.com.au:/usr/src/sys/compile/gsmx
CPU: Pentium Pro (267.32-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x633 Stepping=3
Features=0x80f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,MMX>
real memory = 67108864 (65536K bytes)
avail memory = 63406080 (61920K bytes)
Probing for devices on PCI bus 0:
chip0 <generic PCI bridge (vendor=8086 device=7180 subclass=0)> rev 3 on
pci0:0:0
chip1 <generic PCI bridge (vendor=8086 device=7181 subclass=4)> rev 3 on
pci0:1:0
chip2 <Intel 82371AB PCI-ISA bridge> rev 1 on pci0:7:0
chip3 <Intel 82371AB IDE interface> rev 1 on pci0:7:1
chip4 <Intel 82371AB USB interface> rev 1 int d irq 11 on pci0:7:2
chip5 <Intel 82371AB Power management controller> rev 1 on pci0:7:3
vga0 <VGA-compatible display device> rev 0 int a irq 10 on pci0:9:0
tx0 <SMC 83c170> rev 6 int a irq 9 on pci0:10:0
tx0: address 00:e0:29:24:34:1f, type SMC9432TX, phy QS6612, Auto-Neg 10Mbps
Probing for devices on PCI bus 1:
Probing for PnP devices:
CSN 1 Vendor ID: CTL00f0 [0xf0008c0e] Serial 0xffffffff
pcm1 (SB16pnp <Vibra16X> sn 0xffffffff) at 0x220 irq 5 drq 1 flags 0x13 id 14
Probing for devices on the ISA bus:
sc0 at 0x60-0x6f irq 1 on motherboard
sc0: VGA color <12 virtual consoles, flags=0x0>
lpt0 at 0x378-0x37f irq 7 on isa
lpt0: Interrupt-driven port
lp0: TCP/IP capable interface
psm0 at 0x60-0x64 irq 12 on motherboard
psm0: model Generic PS/2 mouse, device ID 0
sio0 at 0x3f8-0x3ff irq 4 on isa
sio0: type 16550A
sio1 at 0x2f8-0x2ff irq 3 on isa
sio1: type 16550A
pcm0 not found at 0xffffffff
pca0 on motherboard
pca0: PC speaker audio driver
wdc0 at 0x1f0-0x1f7 irq 14 flags 0x80ff80ff on isa
wdc0: unit 0 (wd0): <FUJITSU MPB3064ATU E>, 32-bit, multi-block-16
wd0: 6187MB (12672450 sectors), 13410 cyls, 15 heads, 63 S/T, 512 B/S
wdc0: unit 1 (atapi): <CD-ROM CDU611/2.0a>, removable, accel, dma, iordis
wcd0: 1723KB/sec, 256KB cache, audio play, 16 volume levels, ejectable tray
wcd0: no disc inside, unlocked
wcd0: mode 2 form 1(XA) 2, multisession, CD-DA read stream, comb. rw, rw
corr., ISRC, UPC
wdc1 at 0x170-0x177 irq 15 flags 0x80ff80ff on isa
wdc1: unit 0 (wd2): <QUANTUM FIREBALL_TM1280A>, 32-bit, multi-block-16
wd2: 1222MB (2503872 sectors), 2484 cyls, 16 heads, 63 S/T, 512 B/S
fdc0 at 0x3f0-0x3f7 irq 6 drq 2 on isa
fdc0: FIFO enabled, 8 bytes threshold
fd0: 1.44MB 3.5in
npx0 flags 0x1 on motherboard
npx0: INT 16 interface
apm0 on isa
apm: found APM BIOS version 1.1
joy0 at 0x201 on isa
joy0: joystick
Peter
--
Peter Jeremy (VK2PJ) peter.jer...@alcatel.com.au
Alcatel Australia Limited
41 Mandible St Phone: +61 2 9690 5019
ALEXANDRIA NSW 2015 Fax: +61 2 9690 5982
To Unsubscribe: send mail to majord...@freebsd.org
with "unsubscribe freebsd-current" in the body of the message
