On Tue, 15 Feb 2000, Peter Wemm was heard blurting out:
> Ron 'The InSaNe One' Rosson wrote:
> > On Sun, 13 Feb 2000, MIHIRA Yoshiro was heard blurting out:
> >
> > > [EMAIL PROTECTED] wrote:
> > >
> > > >> Ron 'The InSaNe One' Rosson wrote:
> > > >> > Under 3.3-RELEASE with PAO the sound card work with this entry in the
> > > >> > config file:
> > > >> >
> > > >> > device pcm0 at isa? port ? tty irq 5 drq 1 flags 0x0
> > > >> >
> > > >> > Here is what the dmesg output looked like with that entry:
> > > >> >
> > > >> > pcm0 at 0x220 irq 5 drq 1 on isa
> > > >> > ESS1879 (rev 11, native mode)
> > > >> >
> > > >> > Now under current I have tried both of these entries to get sound
> > > >> > working to no avail.
> > > >> >
> > > >> > device pcm0 at isa? port? irq 5 drq 1 flags 0x0
> > > >> >
> > > >> > device pcm0 at isa? port? irq 5 drq 1 flags 0x15
> > > >> >
> > > >> > Any assistance in this matter would be greatly appreciated.
> > >
> > > device pcm0
> > > device sbc0 at isa? port 0x220 irq 5 drq 1 flags 0x0
> >
> >
> > The above worked.. here is the dmesg output of it:
> >
> > sbc0: <ESS 688> at port 0x220-0x22f irq 5 drq 1 on isa0
> > pcm0: <SB DSP 3.01 (ESS mode)> on sbc0
> >
> > and
> > insane-mental> cat /dev/sndstat
> > FreeBSD Audio Driver (newpcm) Feb 12 2000 16:45:04
> > Installed devices:
> > pcm0: <SB DSP 3.01 (ESS mode)> at io 0x220 irq 5 drq 1 (1p/1r channels)
> >
> > The only issue I have left is that when a sound is played everuything is
> > find till the end and it sounds like a fading echo.
>
> Did you actually try:
> options PNPBIOS
> device pcm
> device sbc
> It is important that you do this please, at least so we have a datapoint.
> Also, what version of -current? (if it's fairly new, you can even leave out
> 'device sbc' if you are running in PnP or PNPBIOS mode)
>
> I presume this is for a laptop, right? (you mentioned PAO but otherwise gave
> no clues). Does 'pnpinfo' report a pnp device? or is it a bios configured
> non-pnp chip on the motherboard? (in which case PNPBIOS should find it)
>
Peter, Everyone,
I did the recommendations Peter requested. It finds the sound card.
The sound card still has the fading echo problem.
I apologize for not mentioning this sooner but this is on a Fujitsu
E360 Lifebook. I håve also attacthed the dmesg for it now with its
current kernel. The thing that gets me is al the unknowns listed.
TIA
--
-------------------------------------------------------------------
Ron Rosson ... and a UNIX user said ...
The InSaNe One rm -rf *
[EMAIL PROTECTED] and all was /dev/null and *void()
-------------------------------------------------------------------
Today's Quote: "It's important to pay close attention in
school----for years I thought that bears masturbated all
winter." ---Damon R. Milhem
Copyright (c) 1992-2000 The FreeBSD Project.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
FreeBSD 4.0-20000208-CURRENT #12: Tue Feb 15 09:37:38 PST 2000
root@mental:/usr/src/sys/compile/MENTAL
Timecounter "i8254" frequency 1193182 Hz
CPU: Pentium II/Pentium II Xeon/Celeron (331.83-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x66a Stepping = 10
Features=0x183f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR>
real memory = 67018752 (65448K bytes)
config> en pcic0
config> po pcic0 0x3e0
config> ir pcic0 11
config> iom pcic0 0xd0000
config> f pcic0 0
config> q
avail memory = 61784064 (60336K bytes)
Preloaded elf kernel "kernel" at 0xc0305000.
Preloaded userconfig_script "/boot/kernel.conf" at 0xc030509c.
Pentium Pro MTRR support enabled
md0: Malloc disk
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Intel 82443BX host to PCI bridge (AGP disabled)> on motherboard
pci0: <PCI bus> on pcib0
isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
ata-pci0: <Intel PIIX4 ATA-33 controller> port 0xf4f0-0xf4ff at device 7.1 on pci0
ata0 at 0x01f0 irq 14 on ata-pci0
ata1 at 0x0170 irq 15 on ata-pci0
pci0: Intel 82371AB/EB (PIIX4) USB controller (vendor=0x8086, dev=0x7112) at 7.2 irq 9
chip1: <Intel 82371AB Power management controller> port 0xff80-0xff8f at device 7.3 on
pci0
pci0: unknown card (vendor=0x11c1, dev=0x0440) at 16.0 irq 9
pcic-pci0: <TI PCI-1221 PCI-CardBus Bridge> irq 9 at device 19.0 on pci0
pcic-pci1: <TI PCI-1221 PCI-CardBus Bridge> irq 9 at device 19.1 on pci0
vga-pci0: <Trident model 9388 VGA-compatible display device> mem
0xfe800000-0xfebfffff,0xfedc0000-0xfeddffff,0xfe400000-0xfe7fffff at device 20.0 on
pci0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
ata-isa0: already registered as ata0
ata-isa1: already registered as ata1
atkbdc0: <keyboard controller (i8042)> at port 0x60-0x6f on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <16 virtual consoles, flags=0x200>
pcic: management irq 11
pcic0: <VLSI 82C146> at port 0x3e0 iomem 0xd0000 irq 11 drq 0 on isa0
pccard0: <PC Card bus -- kludge version> on pcic0
pccard1: <PC Card bus -- kludge version> on pcic0
pcic1: not probed (disabled)
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode
ppi0: <Parallel I/O> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
plip0: <PLIP network interface> on ppbus0
unknown0: <PNP0c01> at iomem 0-0x9ffff,0xe8000-0xfffff,0x100000-0x3ffffff on isa0
unknown1: <PNP0c02> at port 0x4d0-0x4d1,0xff00-0xff3f,0xff80-0xff8f on isa0
unknown2: <PNP0c02> at port
0x80,0x22,0xb2-0xb3,0x72-0x77,0x92,0xf800-0xf87f,0xf880-0xf8ff,0xfd60-0xfd67 iomem
0xfff80000-0xffffffff on isa0
unknown3: <PNP0c04> at port 0xf0-0xff irq 13 on isa0
unknown: <PNP0800> can't assign resources
unknown: <PNP0303> can't assign resources
unknown4: <PNP0200> at port 0-0xf,0x81-0x8f,0xc0-0xdf drq 4 on isa0
unknown: <PNP0000> can't assign resources
unknown5: <PNP0100> at port 0x40-0x43 irq 0 on isa0
unknown6: <PNP0b00> at port 0x70-0x71 irq 8 on isa0
unknown7: <PNP0a03> at port 0xcf8-0xcff on isa0
unknown: <PNP0f13> can't assign resources
unknown: <PNP0501> can't assign resources
unknown8: <SMCf010> at port 0x2e8-0x2ef,0x118-0x11f irq 3 drq 3 on isa0
unknown: <PNP0700> can't assign resources
unknown9: <ESS0009> at port 0x800-0x807 on isa0
sbc0: <ESS ES1879> at port 0x220-0x22f,0x388-0x38b,0x330-0x331 irq 5 drq 1,5 on isa0
pcm0: <SB DSP 3.01 (ESS mode)> on sbc0
unknown10: <ESS0001> at port 0x201 on isa0
unknown: <PNP0400> can't assign resources
unknown11: <PNP0e03> at port 0x3e0-0x3e1 on isa0
IP Filter: initialized. Default = pass all, Logging = enabled
IP Filter: v3.3.6
pccard: card inserted, slot 1
ata1-slave: ata_command: timeout waiting for intr
ata1-slave: identify failed
ad0: 6194MB <TOSHIBA MK6409MAV> [13424/15/63] at ata0-master using UDMA33
acd0: CDROM <UJDA170> at ata1-master using WDMA2
Mounting root from ufs:/dev/ad0s2a
devclass_alloc_unit: ed0 already exists, using next available unit number
ed1 at port 0x240-0x25f irq 10 slot 1 on pccard1
ed1: address 00:e0:98:72:e8:19, type Linksys (16 bit)
