Michael Reifenberger wrote:
> Hi,
> after upgrading my Tecra-8000 to -current as of -now I get the attached output
> during boot.
> And the ep0 driver doesnt get attached with the following message:
> Cannot allocate ports 0x240-0x24f
I have been getting the same with yesterday's and today's world but since I have
another problem with ed0 I was blaming it on some of my tests with the driver.
Friday's world is working fin for me except for a change especially for ed0.
ciao,
ed
>
>
> Does the output look normal? Particularly the muliple attaches worries me.
>
> Does anyone else see this?
>
> BTW: I have machdep.pccard.pcic_irq="11" in loader.conf.local if it matters.
>
> Bye!
> ----
> Michael Reifenberger
> Plaut Software GmbH, R/3 Basis
>
> ------------------------------------------------------------------------
> Name: dmesg.out.gz
> dmesg.out.gz Type: unspecified type (APPLICATION/octet-stream)
> Encoding: BASE64
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
