In <[EMAIL PROTECTED]> Chris D.
Faulhaber <[EMAIL PROTECTED]> wrote:
> On Mon, 11 Oct 1999, Nickolay Dudorov wrote:
>
>> Does anybody successfully use ports/sysutils/{lmmon|chm}
>> with the Abit's BP6 motherboard ?
>>
>> After 'make install'-ing ports and adding
>>
>> controller smbus0
>> controller iicbus0
>> controller iicbb0
>> controller intpm0
>> device smb0 at smbus?
>>
>> to kernel config file (and config, make depend, make, make install,
>> reboot the new kernel) I only receive:
>>
>> IOCTL: device not configured
>>
>> from lmmon and chm.
>>
>
> This is due to the intpm controller not configuring the motherboards PM
> controller, not because the software.
>
> I emailed Takanori Watanabe a while back concerning this MB. His thoughts
> were that: 1) He hadn't heard of the driver working in an SMP environment;
> 2) It may be due to the controller using an unconfigured ISA interface.
Additional information:
When I remove one of the CPUs and boot UP kernel on the same
motherboard both 'chm' and 'lmmon' starts to work (also showed
values for -5V and -12V looks strange).
So the problems is in driver not working in SMP
system. Are there any (general) hints where to look for
such UP/SMP problems ?
N.Dudorov
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
