Using FreeBSD 4.0 current for quite some time and staying current with cvsup work fine for me a few months. But today shit hits the fan, after a make world my system won't boot without errors and manual interference.. ---------------- last part of dmesg after boot -v --------- : changing root device to da0s1a da0 at ncr0 bus 0 target 0 lun 0 da0: <SEAGATE ST34371W SUN4.2G 7462> Fixed Direct Access SCSI-2 device da0: Serial Number JDW582790LFGXG da0: 40.000MB/s transfers (20.000MHz, offset 15, 16bit), Tagged Queueing Enabled da0: 4094MB (8385121 512 byte sectors: 255H 63S/T 521C) da0s1: type 0xa5, start 0, end = 8385120, size 8385121 da0s1: C/H/S end 521/242/10 (1268459) != end 8385120: invalid start_init: trying /sbin/init file: table is full file: table is full file: table is full file: table is full ------------------------------------------------------------ The console reports instead of the file: lines: .: out of file descriptors Enter full pathname of shell or RETURN for /bin/sh: I can let it go to multiuser when i do the following: exec /etc/rc and type CTRL-C/D a couple of times, letting it skip the first processes it start. I don't know where to look, the msgs assume there is something wrong with the disk/filesystems (da0s1: C/H/S end 521/242/10 (1268459) != end 8385120: invalid ) But i can fsck and mount them all without errors... There are no full filesystems: zappa# df -k Filesystem 1K-blocks Used Avail Capacity Mounted on /dev/da0s1a 99183 22952 68297 25% / /dev/da0s1h 1205119 502981 605729 45% /dump /dev/da0s1e 1016303 791947 143052 85% /usr /dev/da0s1f 744175 256046 428595 37% /usr/src /dev/da0s1g 744175 6214 678427 1% /var procfs 4 4 0 100% /proc After the manual multi-user mode I can even do a new make world and make kernel but it doesn't change anything. Something in the early /sbin/init part goes wrong, can anyone describe the boot process in this stage? Regards, Ron. To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-current" in the body of the message
