Hello,
Just cvsup'd and running...
FreeBSD snafu.adept.org 4.0-CURRENT FreeBSD 4.0-CURRENT #0: Thu Aug 5 04:51:08
PDT 1999 [EMAIL PROTECTED]:/usr/src/sys/compile/SNAFU i386
I have the following onboard...
ide_pci0: <Intel PIIX4 Bus-master IDE controller> at device 7.1 on pci0
and I just installed a Promise Ultra66. Here's my relevant kernel config
stuff (following LINT's example):
controller wdc0 at isa? port IO_WD1 irq 14
disk wd0 at wdc0 drive 0
disk wd1 at wdc0 drive 1
controller wdc1 at isa? port IO_WD2 irq 15
disk wd2 at wdc1 drive 0
disk wd3 at wdc1 drive 1
controller wdc2 at isa? port 0 irq ? flags 0xa0ffa0ff
disk wd4 at wdc2 drive 0
disk wd5 at wdc2 drive 1
controller wdc3 at isa? port 0 irq ? flags 0xa0ffa0ff
disk wd6 at wdc3 drive 0
disk wd7 at wdc3 drive 1
Dmesg shows my onboard controller, and all attached devices. Nothing
seems to be shown for the Promise card, or the attached drives (two IBM
10GXPs)... Here's dmesg:
Copyright (c) 1992-1999 The FreeBSD Project.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
FreeBSD 4.0-CURRENT #0: Thu Aug 5 04:51:08 PDT 1999
[EMAIL PROTECTED]:/usr/src/sys/compile/SNAFU
Timecounter "i8254" frequency 1193182 Hz
Timecounter "TSC" frequency 299942803 Hz
CPU: Pentium II (299.94-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x633 Stepping = 3
Features=0x80f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,MMX>
real memory = 134217728 (131072K bytes)
avail memory = 127565824 (124576K bytes)
Pentium Pro MTRR support enabled
Probing for PnP devices:
CSN 1 Vendor ID: CTL00c7 [0xc7008c0e] Serial 0x1c422c08 Comp ID: PNPb02f [0x2fb0d041]
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Intel 82443LX (440 LX) host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <Intel 82443LX (440 LX) PCI-PCI (AGP) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
vga-pci0: <NVidia Riva128 graphics accelerator> irq 9 at device 0.0 on pci1
isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
ide_pci0: <Intel PIIX4 Bus-master IDE controller> at device 7.1 on pci0
chip1: <UHCI USB controller> irq 11 at device 7.2 on pci0
chip2: <Intel 82371AB Power management controller> at device 7.3 on pci0
pci0: unknown card DBZ4d38 (vendor=0x105a, dev=0x4d38) at 14.0 irq 9
xl0: <3Com 3c900-COMBO Etherlink XL> irq 11 at device 16.0 on pci0
xl0: Ethernet address: 00:60:08:a0:55:09
xl0: selecting 10baseT transceiver, half duplex
isa0: <ISA bus> on motherboard
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
wdc0 at port 0x1f0-0x1f7 irq 14 on isa0
wdc0: unit 0 (wd0): <IBM-DHEA-38451>
wd0: 8063MB (16514064 sectors), 16383 cyls, 16 heads, 63 S/T, 512 B/S
wdc1 at port 0x170-0x177 irq 15 on isa0
wdc1: unit 0 (atapi): <TOSHIBA CD-ROM XM-6102B/1106>, removable, accel, ovlap, dma,
iordy
wcd0: drive speed 4133 - 4134KB/sec, 256KB cache
wcd0: supported read types: CD-R, CD-RW, CD-DA
wcd0: Audio: play, 255 volume levels
wcd0: Mechanism: ejectable tray
wcd0: Medium: no/blank disc inside, unlocked
atkbdc0: <keyboard controller (i8042)> at port 0x60-0x6f on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model IntelliMouse, device ID 3
vga0: <Generic ISA VGA> at port 0x3b0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <16 virtual consoles, flags=0x200>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1: configured irq 3 not in bitmap of probed irqs 0
ppc0 at port 0x378-0x37f irq 7 flags 0x40 on isa0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
lpt0: <generic printer> on ppbus 0
lpt0: Interrupt-driven port
ppi0: <generic parallel i/o> on ppbus 0
changing root device to wd0s1a
I can decipher my AWE64 clearly from pnpinfo, but that's about it, here's
the output:
Checking for Plug-n-Play devices...
Card assigned CSN #1
Vendor ID CTL00c7 (0xc7008c0e), Serial Number 0x1c422c08
PnP Version 1.0, Vendor Version 16
Device Description: Creative AWE64 PnP
*** Small Vendor Tag Detected
Logical Device ID: CTL0045 0x45008c0e #0
Device Description: Audio
TAG Start DF
Good Configuration
IRQ: 5 - only one type (true/edge)
DMA: channel(s) 1
8-bit, not a bus master, count by byte, , Compatibility mode
DMA: channel(s) 5
16-bit, not a bus master, , count by word, Compatibility mode
I/O Range 0x220 .. 0x220, alignment 0x1, len 0x10
[16-bit addr]
I/O Range 0x330 .. 0x330, alignment 0x1, len 0x2
[16-bit addr]
I/O Range 0x388 .. 0x388, alignment 0x1, len 0x4
[16-bit addr]
TAG Start DF
Acceptable Configuration
IRQ: 5 7 9 10 - only one type (true/edge)
DMA: channel(s) 0 1 3
8-bit, not a bus master, count by byte, , Compatibility mode
DMA: channel(s) 5 6 7
16-bit, not a bus master, , count by word, Compatibility mode
I/O Range 0x220 .. 0x280, alignment 0x20, len 0x10
[16-bit addr]
I/O Range 0x300 .. 0x330, alignment 0x30, len 0x2
[16-bit addr]
I/O Range 0x388 .. 0x388, alignment 0x1, len 0x4
[16-bit addr]
TAG Start DF
Acceptable Configuration
IRQ: 5 7 9 10 - only one type (true/edge)
DMA: channel(s) 0 1 3
8-bit, not a bus master, count by byte, , Compatibility mode
DMA: channel(s) 5 6 7
16-bit, not a bus master, , count by word, Compatibility mode
I/O Range 0x220 .. 0x280, alignment 0x20, len 0x10
[16-bit addr]
I/O Range 0x300 .. 0x330, alignment 0x30, len 0x2
[16-bit addr]
TAG Start DF
Acceptable Configuration
IRQ: 5 7 9 10 - only one type (true/edge)
DMA: channel(s) 0 1 3
8-bit, not a bus master, count by byte, , Compatibility mode
DMA: channel(s) 5 6 7
16-bit, not a bus master, , count by word, Compatibility mode
I/O Range 0x220 .. 0x280, alignment 0x20, len 0x10
[16-bit addr]
TAG Start DF
Acceptable Configuration
IRQ: 5 7 9 10 - only one type (true/edge)
DMA: channel(s) 0 1 3
8-bit, not a bus master, count by byte, , Compatibility mode
I/O Range 0x220 .. 0x280, alignment 0x20, len 0x10
[16-bit addr]
I/O Range 0x300 .. 0x330, alignment 0x30, len 0x2
[16-bit addr]
I/O Range 0x388 .. 0x388, alignment 0x1, len 0x4
[16-bit addr]
TAG Start DF
Acceptable Configuration
IRQ: 5 7 9 10 - only one type (true/edge)
DMA: channel(s) 0 1 3
8-bit, not a bus master, count by byte, , Compatibility mode
I/O Range 0x220 .. 0x280, alignment 0x20, len 0x10
[16-bit addr]
I/O Range 0x300 .. 0x330, alignment 0x30, len 0x2
[16-bit addr]
TAG Start DF
Acceptable Configuration
IRQ: 5 7 9 10 - only one type (true/edge)
DMA: channel(s) 0 1 3
8-bit, not a bus master, count by byte, , Compatibility mode
I/O Range 0x220 .. 0x280, alignment 0x20, len 0x10
[16-bit addr]
TAG Start DF
Sub-optimal Configuration
IRQ: 5 7 9 10 - only one type (true/edge)
DMA: channel(s) 0 1 3
8-bit, not a bus master, count by byte, , Compatibility mode
DMA: channel(s) 5 6 7
16-bit, not a bus master, , count by word, Compatibility mode
I/O Range 0x220 .. 0x280, alignment 0x20, len 0x10
[16-bit addr]
I/O Range 0x300 .. 0x330, alignment 0x10, len 0x2
[16-bit addr]
I/O Range 0x388 .. 0x394, alignment 0x4, len 0x4
[16-bit addr]
TAG End DF
Logical Device ID: CTL7002 0x02708c0e #1
Compatible Device ID: PNPb02f (2fb0d041)
Device Description: Game
TAG Start DF
Good Configuration
I/O Range 0x200 .. 0x200, alignment 0x1, len 0x8
[16-bit addr]
TAG Start DF
Acceptable Configuration
I/O Range 0x200 .. 0x208, alignment 0x8, len 0x8
[16-bit addr]
TAG End DF
Logical Device ID: CTL0022 0x22008c0e #2
Device Description: WaveTable
TAG Start DF
Good Configuration
I/O Range 0x620 .. 0x620, alignment 0x1, len 0x4
[16-bit addr]
TAG Start DF
Acceptable Configuration
I/O Range 0x620 .. 0x680, alignment 0x20, len 0x4
[16-bit addr]
TAG End DF
*** Small Vendor Tag Detected
End Tag
Successfully got 69 resources, 3 logical fdevs
-- card select # 0x0001
CSN CTL00c7 (0xc7008c0e), Serial Number 0x1c422c08
Logical device #0
IO: 0x0220 0x0330 0x0388 0x0000 0x0000 0x0000 0x0000 0x0000
IRQ 5 0
DMA 1 5
IO range check 0x00 activate 0x01
Logical device #1
IO: 0x0200 0x0000 0x0000 0x0000 0x0000 0x0000 0x0000 0x0000
IRQ 0 0
DMA 4 4
IO range check 0x00 activate 0x01
Logical device #2
IO: 0x0620 0x0000 0x0000 0x0000 0x0000 0x0000 0x0000 0x0000
IRQ 0 0
DMA 4 4
IO range check 0x00 activate 0x01
I'm placing a harddrive on the onboard controller's primary master port,
CD-ROM on the secondary master, and a harddrive on each of the Promise's
master ports... so as not to run any slaved drives.
Maybe my mistake is obvious somewhere where it's not 6AM.
-Mike
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
