Did I miss something? - where does it it get the rtl & compiler source? TIA John
On 18 August 2015 at 16:27, Chris Moody <inqu...@greensnakedesign.com> wrote: > > > On 08/18/2015 01:24 AM, Michael Ring wrote: > > This is how I build fpc trunk cross compiler: > > echo "Building fpchf-linux from trunk" > SUBARCH=armv7 > CROSSOPT="-dREVINC -dFPC_ARMHF -CX -CpARMV7A -CfVFPV3_D16 -OpARMV7A -O2 > -OoFASTMATH -XX -Xs" > //CROSSOPT="-dREVINC -dFPC_ARMHF -CX -CpARMV6 -CfVFPV2 -OpARMV6 -O2 > -OoFASTMATH -XX -Xs" > OPT="-dFPC_ARMHF" > make clean buildbase CROSSINSTALL=1 OS_TARGET=linux CPU_TARGET=arm > OPT="$OPT" OVERRIDEVERSIONCHECK=1 CROSSOPT="$CROSSOPT" > BINUTILSPREFIX=arm-linux-gnueabihf- || exit 1 > sudo make installbase CROSSINSTALL=1 OS_TARGET=linux CPU_TARGET=arm > OPT="$OPT" OVERRIDEVERSIONCHECK=1 CROSSOPT="$CROSSOPT" > BINUTILSPREFIX=arm-linux-gnueabihf- || exit 1 > sudo mv /usr/local/lib/fpc/3.1.1/ppcrossarm > /usr/local/lib/fpc/3.1.1/ppcrossarmhf > > Please note that the rtl is fine for Raspberry Pi 2 (the new quad core > board) as this is a version that uses armv7 commandset. > > For old Raspberry Pi you need to use the commented out CROSSOPT, this will > create rtl that is suitable for old raspberries. > > You should not try to use fpc 2.6.4 as this compiler does not support > armhf. Most likely the 3.0 pre-release will compile the same way, but I > never tried. > > You need to have cross-binutils installed as you need > arm-linux-gnueabihf-* tools to be able to successfully compile. > > Michael > > > Hi Michael, > > Just to make sure, I run the script on the desktop right? just to make > sure its not to be ran on the Pi. > > Thanks again! > > Chris > > _______________________________________________ > fpc-pascal maillist - fpc-pascal@lists.freepascal.org > http://lists.freepascal.org/cgi-bin/mailman/listinfo/fpc-pascal >
_______________________________________________ fpc-pascal maillist - fpc-pascal@lists.freepascal.org http://lists.freepascal.org/cgi-bin/mailman/listinfo/fpc-pascal
