Hello all, After installing fpc 2.4.0 on a freedos directory, I had the following problems:
- I tried to install using the install program, but dosemu crashed when clicking on 'Continue' - So I installed the base package manually, adjusted the path. Now fpc (without arguments) starts correctly, showing all the commandline options. Compiling a program (which compiled identically on Linux without errors), I get a load of errors about GOTO and LABEL not being defined. I recompiled with -Sg, and dosemu crashed again. I tried increasing DPMI memory (from 20 MB to about 50 MB), no difference. The dosemu output is below. Anyone had a similar experience? (NOTE: I tried dosbox too. When I ran 'fpc', the screen output was garbled. Tried several options, but couldn't get that to work). I'm trying to get a program compiled for use under DOS+extender (or win32). I looked up the possibility to cross-compile, but that doesn't seem possible under x86_64 (no 32bit targets)? Help! John ERROR: Fault handler re-entered! signal=11 _trapno=0xE ERROR: cpu exception in dosemu code outside of DPMI client! trapno: 0x0e errorcode: 0x00000007 cr2: 0x00000000 eip: 0x004a2cc1 esp: 0x7fff16e2d270 eflags: 0x00010202 cs: 0x0033 ds: 0x013f es: 0x013f ss: 0x002b ERROR: Please report the contents of ~/.dosemu/boot.log at http://sourceforge.net/tracker/?atid=457447&group_id=49784&func=browse It would be even more helpful if would recompile DOSEMU and reproduce this bug with "debug on" in compiletime-settings. Page fault: write instruction to linear address: 0x00000000 CPU was in user mode Exception was caused by insufficient privilege _______________________________________________ fpc-pascal maillist - fpc-pascal@lists.freepascal.org http://lists.freepascal.org/mailman/listinfo/fpc-pascal
