Re: [fpc-pascal]Can't seem to cycle a new compiler

[kractor]

Vincent Snijders wrote:

On Tue, 02 Mar 2004 15:48:25 -0500
kractor <[EMAIL PROTECTED]> wrote:
 

[EMAIL PROTECTED] wrote:

   

These are known problems.
You must start with a 1.0.10 compiler when you create a new 1.9.X compiler.
Some older (even quite recent) 1.9.x versions won't work.
     

oh, so if i've already built / installed cvs version, then have to 
remove that and re-install 1.0.10 to build updated cvs?
   

Yes, but no complete reinstall is necessary, only the 1.0.10 ppc386.exe.

So next time before you install 1.9.x, save the old (1.0.10) ppc386.exe. For
example rename it to ppc386-release.exe.
HTH,
Vincent.
_______________________________________________
fpc-pascal maillist  -  [EMAIL PROTECTED]
http://lists.freepascal.org/mailman/listinfo/fpc-pascal
 

went so far as to completely reinstall 1.0.10 just to be on the safe 
side, and i'm still getting the same error I was w/ the cvs compiler i 
had been using ...

make -C image clean
Makefile:154: *** The Makefile doesn't support target win32, please run 
fpcmake first.  Stop.
make[2]: Entering directory `C:/CVS/fpc/fcl/image'
make[2]: Leaving directory `C:/CVS/fpc/fcl/image'
make[1]: *** [image_clean] Error 2
make[1]: Leaving directory `C:/CVS/fpc/fcl'
make: *** [fcl_distclean] Error 2

this is the error message i get when trying a "make distclean" in the 
directory to which i fetched the fpc cvs sources

_______________________________________________
fpc-pascal maillist  -  [EMAIL PROTECTED]
http://lists.freepascal.org/mailman/listinfo/fpc-pascal