Dan, This is such a common thing to happen that it must be considered a design fault - and I think that replacement holders should be offered for free or at a particular low price (cost price?) by Polaroid - after all, it's a piece of plastic - what say, David??
That not being the case: I have quite a few slide holders, most of which have had broken (cracked) flexible slide "arms" (around 15). I have repaired them using the very liquid (for high penetration and making a mess :-) ) version of superglue. Open up the crack by pressing moderately hard on the slide arm while applying the glue (don't break it completely off!). Close it and insert a little folded piece of tissue betwen holder and arm to close the crack and create a bit of pressure while drying. Dry off excess glue at once. If this fails, then - repeat above operation - glue a small, oblong piece (say 4 x 6 mm) of plastic on the side of the arm where the crack is (one millimeter thickness is enough). Take care that the thickness allows the slide to be inserted (try it out without glue first on a working arm). Preben ----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, January 14, 2002 9:35 PM Subject: [filmscanners] slide holders for sprintscan I called microtek to see if I could get one of their slideholders for their artixscan 400T, since it will work with the sprintscan 4000. They will sell me one for $60. Yes, that's "SIX-OH DOLLARS" -- WOW. Even polaroid sold them for about $15, and B&H/Adorama used to sell them for $12. If you had "premium support" through polaroid, you used to be able to buy them discounted for as low as $9. But, sixty bucks!? I even had her find one and look at it and describe it to me to be sure this was, in fact, that very item. I think I'll pass while I still have one that's fully in tact. -- --dan Photo Gallery: http://www.danheller.com/ ---------------------------------------------------------------------------- ------------ Unsubscribe by mail to [EMAIL PROTECTED], with 'unsubscribe filmscanners' or 'unsubscribe filmscanners_digest' (as appropriate) in the message title or body ---------------------------------------------------------------------------------------- Unsubscribe by mail to [EMAIL PROTECTED], with 'unsubscribe filmscanners' or 'unsubscribe filmscanners_digest' (as appropriate) in the message title or body
