ping the patchset.
On Tue, Mar 31, 2020 at 10:08:06PM +0800, lance.lmw...@gmail.com wrote:
> From: Limin Wang <lance.lmw...@gmail.com>
>
> Signed-off-by: Limin Wang <lance.lmw...@gmail.com>
> ---
> doc/protocols.texi | 12 ++++++------
> 1 file changed, 6 insertions(+), 6 deletions(-)
>
> diff --git a/doc/protocols.texi b/doc/protocols.texi
> index e510019..7aa7585 100644
> --- a/doc/protocols.texi
> +++ b/doc/protocols.texi
> @@ -1255,7 +1255,7 @@ options.
> This protocol accepts the following options.
>
> @table @option
> -@item connect_timeout
> +@item connect_timeout=@var{milliseconds}
> Connection timeout; SRT cannot connect for RTT > 1500 msec
> (2 handshake exchanges) with the default connect timeout of
> 3 seconds. This option applies to the caller and rendezvous
> @@ -1286,7 +1286,7 @@ IP Type of Service. Applies to sender only. Default
> value is 0xB8.
> @item ipttl=@var{ttl}
> IP Time To Live. Applies to sender only. Default value is 64.
>
> -@item latency
> +@item latency=@var{microseconds}
> Timestamp-based Packet Delivery Delay.
> Used to absorb bursts of missed packet retransmissions.
> This flag sets both @option{rcvlatency} and @option{peerlatency}
> @@ -1297,7 +1297,7 @@ when side is sender and @option{rcvlatency}
> when side is receiver, and the bidirectional stream
> sending is not supported.
>
> -@item listen_timeout
> +@item listen_timeout=@var{microseconds}
> Set socket listen timeout.
>
> @item maxbw=@var{bytes/seconds}
> @@ -1377,7 +1377,7 @@ use a bigger maximum frame size, though not greater than
> @item pkt_size=@var{bytes}
> Alias for @samp{payload_size}.
>
> -@item peerlatency
> +@item peerlatency=@var{microseconds}
> The latency value (as described in @option{rcvlatency}) that is
> set by the sender side as a minimum value for the receiver.
>
> @@ -1389,7 +1389,7 @@ Not required on receiver (set to 0),
> key size obtained from sender in HaiCrypt handshake.
> Default value is 0.
>
> -@item rcvlatency
> +@item rcvlatency=@var{microseconds}
> The time that should elapse since the moment when the
> packet was sent and the moment when it's delivered to
> the receiver application in the receiving function.
> @@ -1407,7 +1407,7 @@ Set UDP receive buffer size, expressed in bytes.
> @item send_buffer_size=@var{bytes}
> Set UDP send buffer size, expressed in bytes.
>
> -@item timeout
> +@item timeout=@var{microseconds}
> Set raise error timeouts for read, write and connect operations. Note that
> the
> SRT library has internal timeouts which can be controlled separately, the
> value set here is only a cap on those.
> --
> 2.9.5
>
--
Thanks,
Limin Wang
_______________________________________________
ffmpeg-devel mailing list
ffmpeg-devel@ffmpeg.org
https://ffmpeg.org/mailman/listinfo/ffmpeg-devel
To unsubscribe, visit link above, or email
ffmpeg-devel-requ...@ffmpeg.org with subject "unsubscribe".
