Sorry, Nicolas. I'm new here. I'll keep the mails short for sure.
Hopefully my next submissions won't take this long to process, as now I
know more about how the entire thing works. Even reading the docs
regarding patch submissions (which I did), there are things that I had
to learn by trial & error until I do it exactly how they're supposed to
be done.
To answer your questions: yes, I've run make fate and built ffmpeg
completely. But specifically for this problem with the HTML docs, the
issue was I didn't have texi2html installed, so the build process wasn't
generating any of the HTML docs (CONFIG_HTMLPAGES = 0), but no warnings
or similar were being shown. For the man pages, those non-escaped "{}"
didn't raise any errors, so I thought it was okay.
Anyway, I hope it gets through now. Everything re-tested.
Thank you for the hints.
Alex.
On 21/12/2019 16:34, Nicolas George wrote:
Alexandre Heitor Schmidt (12019-12-21):
I fixed it again. Some {} weren't escaped by the "@" character, thus causing
this error.
How did this happen? Did you not build ffmpeg completely (and run FATE)
before sending the patch?
Also, could you please trim your mails? >250 lines of quote for just 3
new lines is not a good signal/noise ratio, especially since your mailer
re-wraps quotes (which it should not).
Regards,
_______________________________________________
ffmpeg-devel mailing list
ffmpeg-devel@ffmpeg.org
https://ffmpeg.org/mailman/listinfo/ffmpeg-devel
To unsubscribe, visit link above, or email
ffmpeg-devel-requ...@ffmpeg.org with subject "unsubscribe".
