On Tue, 9 Jan 2018, Marton Balint wrote:
On Thu, 4 Jan 2018, Marton Balint wrote:
The framerate filter was quite convoluted with some filter_frame /
request_frame logic bugs. It seemed easier to rewrite the whole
filter_frame /
request_frame part and also the frame interpolation ratio calculation part
in
one step.
Notable changes:
- The filter now only stores 2 frames instead of 3
- filter_frame outputs all the frames it can to be able to handle
consecutive
filter_frame calls which previously caused early drops of buffered frames.
- because of this, request_frame is largely simplified and it only outputs
frames on flush. Previously consecuitve request_frame calls could cause
the
filter to think it is in flush mode filling its buffer with the same
frames
causing a "ghost" effect on the output.
- PTS discontinuities are handled better
- frames with unknown PTS values are now dropped
Fixes ticket #4870.
Probably fixes ticket #5493.
Will push this soon.
Pushed.
Regards,
Marton
_______________________________________________
ffmpeg-devel mailing list
ffmpeg-devel@ffmpeg.org
http://ffmpeg.org/mailman/listinfo/ffmpeg-devel
