H
I was trying to setup a ffmpeg client to work with an Arecont camera in
multicast and realized that the camera would only return a multicast stream
after an RSTP call, if the SETUP was requested with the following transport:
Transport: RTP/AVP;multicast;client_port=xxxxx
Since the current implementation of the FFMpeg client is sending the transport
the values RTP/AVP/UDP;multicast and this was not being recognized by the
camera, I have changed the FFMpeg code to send the required transport
definition. This way the client started to receive a multicast stream from the
camera.
The diff is the following:
diff --git a/libavformat/rtsp.c b/libavformat/rtsp.c
index c9ffba4..ecbfdf5 100644
--- a/libavformat/rtsp.c
+++ b/libavformat/rtsp.c
@@ -1451,7 +1451,7 @@ int ff_rtsp_make_setup_request(AVFormatContext *s, const
char *host, int port,
else if (lower_transport == RTSP_LOWER_TRANSPORT_UDP_MULTICAST) {
snprintf(transport, sizeof(transport) - 1,
- "%s/UDP;multicast", trans_pref);
+ "%s;multicast;client_port=%d-%d", trans_pref,
rtsp_st->sdp_port, rtsp_st->sdp_port + 1);
}
if (s->oformat) {
av_strlcat(transport, ";mode=record", sizeof(transport));
Could this patch be included in the ffmpeg code?
Best regards,
André Lopes
_______________________________________________
ffmpeg-devel mailing list
ffmpeg-devel@ffmpeg.org
http://ffmpeg.org/mailman/listinfo/ffmpeg-devel
