Hi list,
I have, at home, a old PII 300, mobo from zida (Tomato), with 2
USBs that I've never tested. Now I got a USB mouse and when I connect it
I got that from 'dmesg':
usb-uhci.c: $Revision: 1.259 $ time 17:30:17 Sep 23 2001
usb-uhci.c: High bandwidth mode enabled
PCI: Found IRQ 9 for device 00:07.2
usb-uhci.c: USB UHCI at I/O 0xef80, IRQ 9
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.251:USB Universal Host Controller Interface driver
hub.c: USB new device connect on bus1/1, assigned device number 2
usb-uhci.c: interrupt, status 2, frame# 1215
usb.c: USB device not accepting new address=2 (error=-110)
hub.c: USB new device connect on bus1/1, assigned device number 3
usb-uhci.c: interrupt, status 2, frame# 1465
usb.c: USB device not accepting new address=3 (error=-110)
I've even got my Voodoo TVout worked! TV card too. Full divx videos and
so on. Now only USB is missing to make system complete (at least by now
:). Perhaps I must say that in Winblows 2k it didn't worked either, but,
actually, I don't care about winblows.
Many thanks in advance for any help or suggestion.
-----------------------
Alan Wilter S. da Silva
-----------------------
Laborat�rio de F�sica Biol�gica
Instituto de Biof�sica Carlos Chagas Filho
Universidade do Brasil/UFRJ
Rio de Janeiro, Brasil
Want to buy your Pack or Services from MandrakeSoft?
Go to http://www.mandrakestore.com
