Since you have both a USB1.0 and a USB2.0 what happens when you use both statements in you modules.conf file?
alias usb-interface usb-uhci alias usb-interface ehci-hcd Larry Andy wrote: > Hi, > > I'm trying to get USB 2 working under Mandrake 8.2, so far it fails to > operate correctly when I use -- "alias usb-interface ehci-hcd" in > modules.conf. Motherboard has a VIA VT8235 southbridge. > > If I use "alias usb-interface usb-uhci" then USB works fine as USB ver 1.0 @ > 12 MB/s. With 3 root hubs and 2 ports each. > > I have a Epson C42UX and a Freecom FX-1 CD-RW which are both detected in > UsbView (/proc/bus/usb/devices) correctly and I have no problems printing, > (haven't tried the FX-1 yet). > > As soon as I switch modules to "alias usb-interface ehci-hcd" the ehci > module is picked up and configured (or so messages log tells me), however > UsbView only reports 1 root hub (USB ver 2.0 @ 480 MB/s) but with 6 ports!! > > As soon as a device is plugged in get the following kernel error; > > kernel: ehci-hub.c: GetStatus port 1 status 0x1803 POWER speed=2 CSC > CONNECT > kernel: hub.c: Cannot enable port 1 of hub 1, disabling port > kernel: hub.c: Maybe the USB cable is bad? > kernel: ehci-hcd.c: 00:10.3: free_config devnum 0 > > Any ideas? > > Thanks > > Andy > > > > > > > > > > > ------------------------------------------------------------------------ > > Want to buy your Pack or Services from MandrakeSoft? > Go to http://www.mandrakestore.com
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
