On many dual port ethernet cards, the rj45 is enabled automatically if the BNC port is not terminated with 50 ohm terminations at each end of the cable, Have you made sure the network is connected to the card and is correctly terminated on boot up ?
HTH Pierfrancesco Tateo wrote: > > No jumper , I discover to setup using dos disk saled with the cards. > > But how to do with my old pcmcia ethernet card that have BNC and RJ connector > ? > > Pierfrancesco > > Will wrote: > > > I don't know about the Realtek specifically, but most of those BNC/RJ45 combo > > cards I've seen have a jumper to set which port they use. > > > > On Tuesday 20 November 2001 09:46 am, Pierfrancesco Tateo wrote: > > > Using MDK80 Realtek 8029 > > > > > > How to activate the BNC connection instead of RJ ? > > > > > > Best Regards > > > > > > Pierfrancesco Tateo > > > > > > > > > > > -- Richard Bown Ericsson Microwave Systems AB SE-431 84 M�lndal e-mail [EMAIL PROTECTED] tel +46 31 74 72422 mobile +46 7098 72422
Want to buy your Pack or Services from MandrakeSoft? Go to http://www.mandrakestore.com
