Hello all. I've just installed Mandrake 8 (several times) onto one of my home workstations. The problem I'm having is that after completing the install successfully, on reboot lilo prints "LI 01 01 01...." ad infinitum. The boot disk created during install does the same. I've tried putting the / partition under the 1024 cyl mark, but it doesn't change anything. I have completed the install at least 5 times, using GRUB, LILO. Any suggestions to try will be appreciated and replied to. Note that I'm not currently on the mailing list, so cc: replies to me directly. I'll give more detailed information to anyone who requests it. This configuration is definitely all OK, I'm currently runnin Win2K fine with never any issues, and just removed Debian 2.2r2 to install Mandrake 8. The drive is set up as a 40GB RAID0, with 1 4GB NTFS boot partition, and 1 10GB data drive. I have tried setting up Mdk8 as both SDA3 and SDA5 above and below the 1024 cylinder limit, no change. Thanks for any help! Cheers, /eli HW Setup: Tyan 1834D MB, w/ 2x PIII-450 512MB PC133 3Ware 3200 IDE Raid (current BIOS, w/ 2x20GB WD Caviar 7200) Advansys 960 Ultra (controlling 2 Plextor drives) LS-120 (only device on IDE channel 1, CH2 Disabled) ATI Radeon 64M Creative ES1371
