Thanks for responding. I was away for a few days and therefore did not get
to it till now.
I did as you suggested. However, under print setup (upper right hand part
of dialog that comes up when
you try to print something), I found it was already set for Postscript
level 2. However there was nowhere to put xpp in the "command" entry spot.
The area below the "Postscript level 2" window was blank with browse
available apparently to name a file to print to. Below that was "command" -
but it had no place to enter a command (no window open) so there was nowhere
to put the xpp.
I assumed it was because it was set to print to file, but on the screen
before the setup screen, I toggled the "print to file" both ways without any
change in what I describe.
What do I do to get a field to enter xpp?
Thank you.
Jeff Malka <[EMAIL PROTECTED]>
Registered Linux user 183185
----- Original Message -----
From: Larry Marshall <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Tuesday, February 27, 2001 3:58 AM
Subject: Re: [expert] getting gimp to print under cups
>
> > I have Mandrake 7.1 with CUPS installed. Gimp refuses to print. What
> > should I do to make GIMP recognize and print through cups?
>
> Under print setup (upper right hand part of dialog that comes up when
> you try to print something), set it for Postscript level 2 and then
> put xpp in the "command" entry location. Then save those option
> changes.
>
> Cheers --- Larry
>
>
