Hi!
Thanks for the suggestion, tried it but still hangs..
Dunno, if I was wrong before with hanging on ide-scsi,
but now it hangs on SCSI detection..
When I ran setup in expert mode it hangs after the kernel
has set up ide-controller..
Anyone out there had similar probs with HPT 366?
bye,
Torben
Civileme wrote:
> Yes, skip the ide-scsi detection (install in expert
> mode).
>
> If it loads ide-scsi because you have a burner
> somewhere, try this crazy trick.
>
> Install burner as slave, then switch it to master for
> running.
>
> CIvileme
