Hmm, interesting. Just measured one of mine. When the button is not pressed I see 150 ohms, and 480 ohms when it is pressed. Again Proiximity Pilot to ground.
The control pilot pin should show a 1khz square wave from +12V to -12V My PGP public key: https://vanderwal.us/evdl_pgp.key August 24, 2021 8:13 PM, "Bob Bath via EV" <[email protected]> wrote: > Hey, > It seems the electrician I hired to replace my melted J1772 plug ran the > wiring _along_ the > microswitch instead of underneath it. > Upon testing, the new plug did not work. I’m hoping he didn’t mash the crap > out of the wires and > what appears to be a capacitor or some other discrete component. > Anyone have some ohmmeter readings I should be getting when the switch is > open vs closed? > Guessing 0 ohms when open. 😅 > The plug now does nothing, FYI. Lights on the Aerovironment charger do > nothing. No delay of about > 1.5 sec followed by what sounds like a relay closing. > > Sincerely, > Bob Bath > > Note: any misspellings of the contents of this message are due to 56 y.o. > vision, hyperactive spell > check changing what I typed, or fat fingering— not cluelessness. > >> > > _______________________________________________ > Address messages to [email protected] > No other addresses in TO and CC fields > UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub > ARCHIVE: http://www.evdl.org/archive > LIST INFO: http://lists.evdl.org/listinfo.cgi/ev-evdl.org _______________________________________________ Address messages to [email protected] No other addresses in TO and CC fields UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub ARCHIVE: http://www.evdl.org/archive/ LIST INFO: http://lists.evdl.org/listinfo.cgi/ev-evdl.org
