Even if the electronics are fried, the cord/gun could be connected up
with an Open EVSE type kit to make a new one and retain a lot of the value.
Jay
On 12/10/2015 09:44 AM, EVDL Administrator via EV wrote:
On 9 Dec 2015 at 23:55, brucedp5 via EV wrote:
IMO your drowned-(its dead Jim)-EVSE ... should be laid it to rest in a
recycle-bin.
You might be right, but still ....
I don't make a habit of drowning electronics. However, once while working
on our spring house, I accidentally knocked my nearly-new cordless drill
into the water.
It seemed totally dead. But I took it apart, rinsed the circuit card and
switch in distilled water, and dried everything out. Lo and behold, it
revived, and runs fine to this day.
Steve says he tried "drying and cleaning." He doesn't state how. If he
hasn't tried distilled water, I recommend it. Follow with 24 hours under a
heat lamp.
Lee Hart may have further suggestions.
I just hate to see expensive electronics junked until all avenues of revival
have been explored.
David Roden - Akron, Ohio, USA
EVDL Administrator
= = = = = = = = = = = = = = = = = = = = = = = = = = = = =
EVDL Information: http://www.evdl.org/help/
= = = = = = = = = = = = = = = = = = = = = = = = = = = = =
Note: mail sent to "evpost" and "etpost" addresses will not
reach me. To send a private message, please obtain my
email address from the webpage http://www.evdl.org/help/ .
= = = = = = = = = = = = = = = = = = = = = = = = = = = = =
_______________________________________________
UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub
http://lists.evdl.org/listinfo.cgi/ev-evdl.org
Read EVAngel's EV News at http://evdl.org/evln/
Please discuss EV drag racing at NEDRA (http://groups.yahoo.com/group/NEDRA)
_______________________________________________
UNSUBSCRIBE: http://www.evdl.org/help/index.html#usub
http://lists.evdl.org/listinfo.cgi/ev-evdl.org
Read EVAngel's EV News at http://evdl.org/evln/
Please discuss EV drag racing at NEDRA (http://groups.yahoo.com/group/NEDRA)
