I had the equivalent for my BeagleBone Black which used the co-processor to create the step/dir and ran a version of LinuxCNC called MachineKit. The only thing wrong with the board was that it used NO switches for limit etc. Very dangerous. I did actually run my mill with it for a short time. However Xylotex appears to be gone as is MachineKit.
> -----Original Message----- > From: Sam Sokolik [mailto:[email protected]] > Sent: November 9, 2026 11:19 AM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] raspberry pi and parallel port > > I would second mesa hardware... But.. > > I have one of these and it works 'ok' > > You are pretty limited in step output speed > > https://byte2bot.com/products/parallel-port-raspberry-pi-hat > > In his configs - the base thread is 150000ns - which without reset > functionality (I don't know if the gpio in the rpi allows for that) is > 3.3khz. > > But certainly usable for some things.. > > sam > > On Mon, Nov 9, 2026 at 11:30�AM andy pugh <[email protected]> > wrote: > > > On Mon, 9 Nov 2026 at 01:08, fxkl47BF--- via Emc-users > > <[email protected]> wrote: > > > > > > i have a small cnc router that is driven by the parallel port of a pc > > > i see at "https://www.linuxcnc.org/docs/html/drivers/hal_pi_gpio.html" > > that i can use the gpio pins of a raspberry pi for this > > > is anyone doing this and can you share what you learned > > > > There should be enough pins to replace a parallel port, however you > > might have trouble with voltage levels. > > Does your equipment work properly with 3.3V signals? And are any > > inputs to the Pi at a safe voltage for the Pi? (switches and even > > Proximity sensors can switch-to-gnd so are not a problem there) > > > > I hesitate to recommend them, as PCW has a living to make, but there > > are some cheap clones of the "7i92" board on AliExpress. None of them > > bear any real similarity to a real 7i92, so I am unsure why they > > picked that designation. > > I recently bought one to see what they were like, and to be fair it's > > quite nice, with a DIN-rail mounting case and two ethernet sockets for > > smart-serial expansion boards. > > The only real drawback over a real Mesa board is that the > > documentation is terrible, support is likely to be nonexistent and for > > some reason it insists on two separate 24V supplies, yet all GPIO is > > 5V. > > > > The one that I got was this one: > > https://www.aliexpress.com/item/1005010164851154.html > > As is always the case with AliExpress, you have to look beyond the > > headline price and factor in shipping. And bear in mind that as > > someone else observed "it is like buying stuff from raccoons that have > > no idea what anything is for or what it should cost" > > > > > > -- > > atp > > "A motorcycle is a bicycle with a pandemonium attachment and is > > designed for the especial use of mechanical geniuses, daredevils and > > lunatics." > > � George Fitch, Atlanta Constitution Newspaper, 1912 > > > > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
