> -----Original Message-----
> From: andy pugh [mailto:[email protected]]
>
> On Fri, 14 Aug 2026 at 16:52, John Dammeyer <[email protected]>
> wrote:
>
> > So this breaks Raspberry Pi4 LinuxCNC? Any of the other 32 bit processors
> > running LinuxCNC?
>
> Only PI1 and Pi2 were 32-bit. Pi3 onwards are 64-bit.
>
> I don't know if LinuxCNC runs acceptably, or usefully, on a Pi2.
>
> --
My mistake. For some reason I thought the Pi3 was still 32 bit.
Thanks everyone for the prompt reply.
John
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
