Thanks for the feedback. I did find a LinuxCnc-Mill-jk.pM3 file which is used with the PostHaste Plugin. It produced code that didn't cause LCNC to complain. However I can't figure out how to actually create a .pst file. I have about 28 days left on my GibbsCAM evaluation so perhaps I'll reach out to them. John
> -----Original Message----- > From: Phill Carter via Emc-users [mailto:[email protected]] > Sent: March 27, 2024 9:32 PM > To: linuxcnc-users > Cc: Phill Carter > Subject: Re: [Emc-users] GibbsCAM machine .pst file. > > If you cannot get a post processor for LinuxCNC then another option would > be to run the Fanuc g-code file through a Python filter program to automate > any required changes: > > <http://linuxcnc.org/docs/2.9/html/gui/filter-programs.html> > > > > > On 28 Mar 2024, at 2:01�pm, John Dammeyer <[email protected]> > wrote: > > > > Does anyone have a generic GibbsCAM .pst file for LinuxCNC? > > > > I've generated G-Code for a FANUC but comments start with a '*' and it has > > rigid tapping using G84.1 and G84.2. I replaced those with G84 just to see > > if it would load. Had to add an M3 in front of the S300. > > > > There are probably other issues too that I haven't found yet. > > > > Thanks > > > > John > > > > > > > > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
