On 12/10/23 17:08, alanmthomason--- via Emc-users wrote:
Hi There.I am looking for guidance to build linuxcnc in a way that I can
step through it. I can build currently, but in trying to understand the
underlying code I was hoping to use a debugger to step through it.
I could not find any flags in the configure -help that looked right.
Stepping through code with a debugger is not likely to be
possible in a program that is partially real-time.
Jon
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
