Actually if made the mounting plate out of brass I could soft solder the flat head screws.
-----Original Message----- From: TJoseph Powderly [mailto:[email protected]] Sent: June 25, 2023 6:30 AM To: Enhanced Machine Controller (EMC) Subject: Re: [Emc-users] Drilling holes in the back of a stepper motor drill hole in and tap or glue screws on exterior, thread side out ? ;=} i read the force would be snall outside the box literally tomp On Sun, Jun 25, 2023 at 10:31�AM John Dammeyer <[email protected]> wrote: > > I want to add an encoder onto the back of this stepper motor. I can install > either a US Digital or a CUI since both mounting flanges can extend out near > the edges of the back mounting plate. > > > > Is there any reason I can't clamp the motor in a vice and pop in two holes > and tap them with a bottom tap at the spacing of the mounting flange? > > John > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
