Thanks Peter! El vie., 17 de marzo de 2023 15:54, Peter C. Wallace <[email protected]> escribió:
> On Fri, 17 Mar 2023, Leonardo Marsaglia wrote: > > > Date: Fri, 17 Mar 2023 15:14:28 -0300 > > From: Leonardo Marsaglia <[email protected]> > > Reply-To: "Enhanced Machine Controller (EMC)" > > <[email protected]> > > To: "Enhanced Machine Controller (EMC)" <[email protected] > > > > Subject: [Emc-users] 7i95 stepgen in single ended mode > > > > Hi guys, > > > > Just to be sure. Are the 7i95 stepgen pins meant to be used as single > ended > > besides differential? Because every group of differential pins lie > between > > a ground and a 5v output so I guess this is meant to be used in both ways > > depending on the configuration. > > > > Thanks as always! > > > > Leonardo > > > > > Yes, the step/dir pins can be used single ended or differentially. > > > Differential: > > STEP+ PUL+ > STEP- PUL- > > Single ended sourcing: > > STEP+ PUL+ > GND PUL- > > Single ended sinking: > > +5V PUL+ > STEP- PUL- > > > > > > _______________________________________________ > > Emc-users mailing list > > [email protected] > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > Peter Wallace > Mesa Electronics > > (\__/) > (='.'=) This is Bunny. Copy and paste bunny into your > (")_(") signature to help him gain world domination. > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
