On Fri, 30 Sep 2022, John Dammeyer wrote:
Date: Fri, 30 Sep 2022 13:40:57 -0700
From: John Dammeyer <[email protected]>
Reply-To: "Enhanced Machine Controller (EMC)"
<[email protected]>
To: "'Enhanced Machine Controller (EMC)'" <[email protected]>
Subject: Re: [Emc-users] Linuxcnc configurations using Mesa
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
If you get read errors on a RPI4 and 7I76E, I would double the servo
thread period (the RPI4 is marginal at a 1 KHz servo thread period with
some kernels)
Peter Wallace
Mesa Electronics
So you'd change it to 500Hz or 2kHz?
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
Also forgot to add, you need force_turbo=1 in config.txt
Peter Wallace
Mesa Electronics
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
