Andy and Seb, Well I guess I jumped the gun. I didn’t think anybody was going to have any suggestions, so, I installed Buster and LinuxCNC 2.8.2. I think your suggestions are worth trying so I may try reinstalling Bullseye and see what happens with those suggestions. However, I am tied up at the moment, so, it may take a couple days before I can get to it.
Thanks, Alan > ---------- Forwarded message ---------- > From: andy pugh <[email protected]> > To: "Enhanced Machine Controller (EMC)" <[email protected]> > Cc: > Bcc: > Date: Wed, 11 May 2022 08:49:23 +0100 > Subject: Re: [Emc-users] Linuxcnc development machine > On Mon, 9 May 2022 at 17:02, Alan Condit <[email protected]> wrote: > > > The only problem that I am having is that if I am not using it for a few > minutes it shuts down. Several other Bullseye users have reported similar > behavior. So, I’m wondering if I should go back to Buster? > > Complete shutdown or just display blanking? > Sometimes it can be hard to tell if the machine doesn't want to wake. > > Can you ssh in to it when it is "off" > > Have a look around the seb for disabling dpms as a starting point. > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is > designed for the especial use of mechanical geniuses, daredevils and > lunatics." > — George Fitch, Atlanta Constitution Newspaper, 1912 > > ---------- Forwarded message ---------- > From: Bari <[email protected]> > To: [email protected] > Cc: > Bcc: > Date: Wed, 11 May 2022 03:11:49 -0500 > Subject: Re: [Emc-users] Linuxcnc development machine > On 5/9/22 10:57, Alan Condit wrote: > > I just rebuilt my late 2012 MacMini to be a Debian Bullseye machine. I > setup a development environment on it. I loaded it with the source for > Preempt-RT 5.15.41 and built a 64 bit kernel for my RaspberryPi 4. > > > > The only problem that I am having is that if I am not using it for a few > minutes it shuts down. Several other Bullseye users have reported similar > behavior. So, I’m wondering if I should go back to Buster? > > > > Thanks, > > Alan > > > I have been using Bullseye with LCNC 2.9 for over a month now 24/7 with > no shutdowns or blanking ever. > > Have you turned off the screensaver and turned off blanking in the power > management settings? > > > -Bari _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
