On Tue, 12 Apr 2022, Marius wrote:
Date: Tue, 12 Apr 2022 16:22:37 +0200 From: Marius <[email protected]> Reply-To: "Enhanced Machine Controller (EMC)" <[email protected]> To: "Enhanced Machine Controller (EMC)" <[email protected]> Subject: Re: [Emc-users] Looking for 7i92 bit fileI attached a picture. Don't remember if that can be done.This is the config I need but I will be damned if I can get PnCConf to do this. Maybe I dont understand the GUI where the pin allocations happen that well. If only they would show the I/O number correctly somewhere. There are some numbers on the left side but they make no sense.
The pinout is determined by the firmware so many parallel port type 7I92 bitfiles will do For example 7i92_5ABOBx2D.bit firmware will work here You associate stepgen numbers to Axis in pncconf The firmware maps those numbered stepgens to physical pins
XSTEP - 2 : XDIR -3 X2STEP - 4 : X2DIR - 5 YSTEP - 6 : YDIR - 7 NO Z (or 16 and 17) ASTEP - 8 : ADIR 9 On 2022/04/12 15:50, andy pugh wrote:On Tue, 12 Apr 2022 at 13:48, Marius <[email protected]> wrote:The config I have to replicate is this.Seems to be coming through blank._______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
