Thanks. That's one of the things I was looking for. I still don't know exactly why the PROBE install causes the G-Code program to terminate until the G-Code program has been reloaded. That's for tomorrow or later tonight. But at least I no longer get the double movement at the tool change.
John > -----Original Message----- > From: [email protected] [mailto:[email protected]] > Sent: October-27-21 2:10 PM > To: 'Enhanced Machine Controller (EMC)' > Subject: Re: [Emc-users] Tracking G-Code subroutines > > There's also print and log... > > http://linuxcnc.org/docs/2.8/html/gcode/overview.html#_logging > > -----Original Message----- > From: andy pugh <[email protected]> > Sent: Wednesday, 27 October 2021 7:52 PM > To: Enhanced Machine Controller (EMC) <[email protected]> > Subject: Re: [Emc-users] Tracking G-Code subroutines > > On Wed, 27 Oct 2021 at 08:36, John Dammeyer <[email protected]> wrote: > > > > we don't actually see the calculated parameters from say the G53 lines nor > > whether it fails and the M71 is run. > > Have you tried adding debug lines ot the subroutine? > > (DEBUG, G53 G0 Z #<_ini[AXIS_Z]MAX_LIMIT> + > #<_ini[PROBE_SCREEN]Z_SAFE_TRAVEL_OFFSET>) > > I admit that I am not sure that this works in remaps.... > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is designed for > the especial use of mechanical geniuses, daredevils > and lunatics." > George Fitch, Atlanta Constitution Newspaper, 1912 > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
