On Wed, 20 Oct 2021, Viesturs L?cis wrote:
Date: Wed, 20 Oct 2021 20:32:25 +0300
From: "[UTF-8] Viesturs L?cis" <[email protected]>
Reply-To: "Enhanced Machine Controller (EMC)"
<[email protected]>
To: "Enhanced Machine Controller (EMC)" <[email protected]>
Subject: [Emc-users] How to update 7i71 firmware
Hello again!
I am receiving a message on LinuxCNC startup that 7i71 board has old firmware.
So I have a question (most probably, for PCW) - how exactly should I do it?
I found a zip file with firmware and update scripts here:
http://www.mesanet.com/software/parallel/sserial.zip
I found a readme file in there, but I am not sure I understand
correctly the instructions.
My setup is 5i25 board with 7i77 attached to its P3 connector. And
7i71 is attached to 7i77.
In HalShow 7i71 shows up as hm2_5i25.0.7i71.0.2. That means it is on channel 2.
From readme file it seems that in terminal I should run this command:
./updatess 7i71 5i25 2 7I71R14.BIN
Is that correct? Or should I omit the firmware file name?
No firmware name
I also am not sure that I understand, where the firmware file has to
be placed. In the same folder, where updatess script?
You run the ssinstall script to install the firmware
Or do I have to run ssinstall script before that (with "sudo
./ssinstall") to get the firmware files in correct places?
Viesturs
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
