thanks!
On 2/18/21 4:50 PM, Phill Carter wrote:
On 19 Feb 2021, at 10:45 am, R C <[email protected]> wrote:
Hello,
where in axis can I set the range for the "speed overide", or the ranges for the
"overrides" in general? (I want to use it to speed up the process when using axis for
'simulations')
<http://linuxcnc.org/docs/devel/html/config/ini-config.html#_display_section
<http://linuxcnc.org/docs/devel/html/config/ini-config.html#_display_section>>
thanks,
Ron
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
