On Sunday 28 June 2020 20:24:35 Gene Heskett wrote: > On Sunday 28 June 2020 13:24:24 andy pugh wrote: > > On Sun, 28 Jun 2020 at 18:06, Gene Heskett <[email protected]> > > wrote: > > > And I can't find an "unhomez" pin. Axis as a gui can do it, so > > > where is this pin hiding? > > > > halui.joint.N.unhome > > looked this up in evince, but the startup stuffs [HAL] ... HALUI=halui
[HALUI] # nothing yet turns out to be the correct .ini file syntax and it all magically appears. But after the fault, it doesn't clear the * in front of the axis until F2 has been punched to off the motor power which takes 10 seconds and F2 punched again to restore motor power. Since thats also reseting the x axis in microsteps, I should unhome it all. Thanks Andy. Cheers, Gene Heskett Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) If we desire respect for the law, we must first make the law respectable. - Louis D. Brandeis Genes Web page <http://geneslinuxbox.net:6309/gene> _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
