On 6/28/20 3:52 PM, andy pugh wrote:
On Sun, 28 Jun 2020 at 21:31, Ed <[email protected]> wrote:
SNIP
Yes. I don't do it quite like that any more. I wrote a custom HAL
component that handles the slaving and the jogging. It also (as of
last weekend) handles multi-start hobs.
Oh, and I changed the feed to feed-per-rev of the _blank_ and also
changed the "air feeds" to straight feeds as otherwise they were
painfully slow with high-count gears.
If you want I can send you the whole config folder zipped up, but it
obviously won't be plug-and-play unless you too are using 8i20 and
7i49.
The configs would be great!!
I can probably figure out the differences in a comparison print out.
Thanks, Ed.
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
