Thanks Jon I'll head a look.
Regards Andrew On Sat, Jun 13, 2020, 11:43 AM Jon Elson <[email protected]> wrote: > On 06/12/2020 04:47 AM, andrew beck wrote: > > > > has anyone every retrofitted a pressbrake with linuxcnc? > > > > > Tx/Rx Labs in Houston has a press brake, and I'm pretty sure > it runs LinuxCNC (everything else there does). It is one of > the most amazing makerspaces in the world, but their web > site doesn't have a lot of detail you can look up. > > You might try sending them an email through the web site. > > Jon > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
