I'd be worried about busting off a chunk of the T slot on the top slide by
putting a lot of weight on a long lever arm which lathes aren't designed to
handle.
On Wednesday, June 10, 2020, 3:33:24 PM MDT, andy pugh <[email protected]>
wrote:
On Wed, 10 Jun 2020 at 20:33, Gene Heskett <[email protected]> wrote:
> That would nice but I'm not 100% sure my bxa post could handle a 50 lb
> chuck 2 feet out of balance.
That's 100 ft.lb. A good heave on a long spanner. Would you expect
that to break your toolpost?
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
