On 2020-02-01 20:46, Jon Elson wrote:
On 02/01/2020 08:35 PM, Thomas D. Dean wrote:
I have been using linuxcnc 2.9.0~Pre0 from sources, run in place.
Until today, it has worked, mostly. Before today, about 2x per week
it would freeze and I had to cycle power to get it working. Now,
linuxcnc freezes.
Does it ONLY freeze when LinuxCNC is running? But, just keep working if
you DON'T start LinuxCNC?
In that case, the most likely problem is the BASE_THREAD has too short a
period. Try increasing
the BASE_THREAD period in the .ini file and see if that fixes it.
I changed the BASE_THREAD period by a factor of 10x then 100x, with the
same result.
The OS seems to run fine. I did:
> cd RTAI/linuxcnc
> git pull
> cd src
> make clean
> make
> sudo make setuid
All this went OK. Elapsed time 20 min, or so.
Tom Dean
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
