Have you checked the board for leaking capacitors? Usually the pressure relief
cuts on top of the cans split open.
On Friday, January 31, 2020, 12:51:07 PM MST, dave engvall
<[email protected]> wrote:
Hi all,
A couple of days ago my 525 motherboard crashed. Really crashed! It has
been flaky for months but never any clue as to the problem. This time it
refused to boot so I grabbed a new disc and installed stretch ... iso.
Looks pretty, comes up nicely.
However invoking linuxcnc only brings up the ---sim stuff. I can get at
other stuff thru by-interface but in frustration manually copied the
5i20.ini, hm2-servo.hal, in to configs and edited the ini to reflect
reasonable values for my system. Asked for tklinuxcnc because it is
easy. All that will come up is axis. Tried gmoccapy and got some error
message. Does anything except axis run under stretch? How do i get the
whole tree to display on startup? TIA
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
