Install this on a machine. The accuracy of the machine would not have to be very close. This would allow a VERY cheap machine to manufacture to pretty good tolerances. Maybe a robot arm. Use this with a probe on a robot arm to collect geometric data for inspection.
On Wed, Jan 29, 2020 at 12:30 PM Andy Pugh <[email protected]> wrote: > > > > On 29 Jan 2020, at 20:18, grumpy--- via Emc-users < > [email protected]> wrote: > > > > https://www.youtube.com/watch?v=p_wk3q8jWcs > > It’s one of the best ideas I have seen. Really clever. (I have been > following it for years). > > I have never _quite_ had an excuse to buy one. > > Nice example use a few years ago when it was a new thing. > > https://youtu.be/lfmrvxB154w > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Addressee is the intended audience. If you are not the addressee then my consent is not given for you to read this email furthermore it is my wish you would close this without saving or reading, and cease and desist from saving or opening my private correspondence. Thank you for honoring my wish. _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
