On Tue, 17 Dec 2019, andy pugh wrote:
Date: Tue, 17 Dec 2019 11:32:22 +0000
From: andy pugh <[email protected]>
Reply-To: "Enhanced Machine Controller (EMC)"
<[email protected]>
To: "Enhanced Machine Controller (EMC)" <[email protected]>
Subject: Re: [Emc-users] Latency Warning Messages
On Mon, 16 Dec 2019 at 23:42, John Dammeyer <[email protected]> wrote:
For example. The board in the machine at the moment generates a
Servo Jitter of 33217 and Base Jitter of 131983.
That's fairly terrible.
Out of interest, how well does that machine work with Mach3?
You can get really bad base jitter if you try to run the base thread faster than
the machine is capable of responding (the latency-tests default 40 KHz base
thread is too fast for some systems so you might get considerably better
reported latency at 20 KHz for example)
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
