I have no definite knowledge of the Zeiss probes but isn't the mechanical switch just to indicate an Estop condition for serious overtravel? I believe that there are piezo sensors for the actual probing.
> -----Original Message----- > From: Rene Hopf [mailto:[email protected]] > Sent: Thursday, May 10, 2018 6:34 PM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] Zeiss touch probes > > > > > On 11. May 2018, at 00:29, Andrew <[email protected]> wrote: > > > >> So, working purely as a touch-probe they show 76k? when un-triggered > >> and 90k? when triggered. So I need to find a way to convert that to a > >> digital input for LinuxCNC. > >> (I may well just ignore the piezo element) > > the inputs on the stmbl are analog, and have configurable threshold voltage. > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most engaging > tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
