>
> .
>
>>
>> Use PnCConfo to create a set of HAL, INI and other files, then work on
>> those files directly.
>>
>
Done, verified linuxcnc start up before editing .
>>
>> Change hm2_pci to hm2_eth, and add a "board_ip=..." parameter
>> Tweak the config files until there are no errors and LinuxCNC starts.
>>
> Like the attachment shows ?


  like this.jpg
<https://drive.google.com/file/d/172uhLuixg9eSmWZmzLXW7QeviXoM1Nl1/view?usp=drivesdk>



And a question, how do I get this to copy the print file from linuxcnc .
Ctrl v, c won't do it, print screen won't do it. I understand the error
message will tell us where and it looks to me like it stops when the Hal
file loads , and once that error is cleared we are ready.
  print file.jpg
<https://drive.google.com/file/d/1ITHiYTjDEF1OLra0Swj6v9rPeUKFzFwu/view?usp=drivesdk>

I have the 7i90 manual now in dead tree. I'm working toward the documents
being dead tree but that's going to take a while. I will print off Hal
manual and read in the next 24-48 .
Thank you
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to