On 10 March 2018 at 18:12, Mark <[email protected]> wrote: > net lincurve.0.in (what pin do I net it to that gets the X axis position?)
I think you would need to look to be certain. http://linuxcnc.org/docs/2.7/html/man/man9/motion.9.html I think that axis.0.joint-pos-cmd is likely, but motor-pos-cmd might be the one. I think you want the one that does change on homing. > net lincurve.0.out (what pin do I net this to push the correction to the Z > axis?) With 2.7 to offset.0.in (which you would need to loadrt and addf too) -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
