On 11 March 2018 at 17:36, a k <[email protected]> wrote: > i be honest, i am not smart enough to go into CURA - opensource software to > increase step up in Z direction up to .5" and turn extruder feed off or set > extruder feed to constant.
I just opened Cura and set the layer height to 10mm and it sliced the model at 10mm. The rest you can do in HAL, set the torch to "on" when the extruder axis is moving positive and "off" when the extrude retracts. The ddt component will do this. -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
